Valentines Heart

A simple pendant for valentines day!

You’ll need:
Approx. 5 inches of wire (any gauge)
Round-nosed pliers

Start by bending the wire in half.

Now cross the ends of the wire over each other and twist a few times with your fingers so there is about ¾ inch of wire after the twist.

Use round nosed pliers and curl one side.

Then curl the other side.

Position your round nosed pliers in the middle of your wire oval, and push down (or squish the wire) a little.

Your heart will look kind of strange at this point, but that’s okay.

Finally, using your fingers and pliers round the two sides of your heart.

Slip it on a chain or incorporate it into other jewelry designs.

You could also use red wire.